CINDI family is designed and approved for use in an environment similar to a regular bathroom. It has a user friendly display with easy access where you can adjust incinerating time, see status on the toilet and change language. The display also show you when it is time to empty the ash tray, clean the ash pan or clean the smoke pipe.
CINDI family is optimized for use in a tiny house, in the family cabin or in any building that isn’t connected to the regular sewer system. It only needs ventilation and Power (230V) to function. It has the capacity to handle toilet waste from up to six persons in the household. It is used when needed, even if someone else has just visited the toilet. It keeps track on how many uses and adapts the incinerating length to meet the demand.
When no programme is running, and the toilet is in standby mode, the fan constantly operates at low speed. The purpose of this is to let moisture ventilate out of the toilet and to prevent cold air from getting in to the toilet through the pipe.
When an incineration programme is running, the fan draws air through the incineration chamber to constantly add oxygen to the incineration process. This also enables hot air and smoke to flow through the pipe and out of the chamber.
MPORTANT! As long as the toilet is attached to the ventilation pipe, the power should be turned on. When the fan spins, it prevents moist air from entering the toilet. If the power is turned off, the toilet should be disconnected from the pipe and the pipe plugged to prevent moist air from entering.
CINDI family is a safe toilet. It has a wide Array of built in safety systems that closely monitors the temperature in the oven, inside the toilet and the ventilation temperature. It is also fitted with at “stand alone” over heat protection that works outside the regular firmware. If the temperature in any location gets higher the normal the incinerating process automaticly shuts down and the display informs you of this. The CINDI family is fitted with a magnetic sensor that pauses the incinerating process when you use the toilet, only to resume when your close the lid after use. It is also fitted with a overvoltage protection to make sure the PCB and cabling is protected during a power surge.
Before your visit place a bag in the bowl, the bag protects the bowl from the feces and limits the need for cleaning. Place the bag by lifting the lid and seats, then place the bag. When the bag is places – the toilet is ready to be used. When the visit is completed, use the flush lever to open the hatch to the incineration chamber. When the flush lever is pressed down and the bag of waste falls down to the incineration chamber, release the flush lever and start the incinerating process by selecting a program (large or small). Even if the toilet already is in an ongoing incineration process, it is extremely important to both flush and to implement a pogram. Always start an incineration program after your visit.
EMPTYING THE ASH PAN When the ash pan is full, after c. 50 toilet visits, the message ASH PAN EMPTIED? is shown on the display. Press NO (right button) in order to continue with the incineration program. When the incineration is finished and the toilet has cooled down, empty the ash. The next time an incineration program is started you will see the same message again and then you press YES (left button) if you have emptied the ash.